Connect compatible Reolink cameras to a Raspberry Pi RTMP hub

Published · Updated

Save

Check each camera’s model, firmware and supported protocols before choosing the Raspberry Pi’s role. Reolink RTMP support varies by device. If the camera exposes RTSP, the Pi can pull it and relay to an RTMP service where needed.

Test one camera locally

Enable only the required protocol using the manufacturer’s instructions. On a trusted local network, confirm the stream in a local player and identify its codec, resolution and bitrate. Keep credentials out of published examples and avoid exposing camera or relay ports to the internet.

Size for several cameras

Start by relaying without transcoding where the codecs and output permit it. Measure sustained network throughput and CPU for one feed, then add feeds one at a time. Use separate stream names and access controls. Enable a bounded reconnect policy and verify behavior after an intentional local disconnect.

References

Reolink RTSP compatibility

Reolink protocol support by product

Discuss this answer